![]() ![]() If everything works properly, your problem is fixed. Close up your toilet tank and make sure to put everything back where it came from. Lowering the water level should stop your toilet from using more water than necessary. Release it, lower the float and be sure to re-engage the mechanism. If the float is a cylinder, you should find a mechanism to release it for adjustment. If this is not possible, you can simply bend the arm down. Open the valve by lifting the float to the top position, pressing down on the black plastic cap that covers the valve, and giving it a 1/8 to 1/4 turn. Loosen the screw, lower the arm and tighten the screw again. If the float is a ball on the end of an arm, look for a screw at the base of the arm. It will be either a plastic or rubber ball on the end of a metal arm, or a cylinder mounted on a pipe. The fill valve of your toilet combines with the flush valve to ensure your toilet always has enough water to flush and keep everything clean. Then remove the top of the tank and set it down on the towel. This is a relatively simple procedure, though the actual procedure will vary depending on the kind of fill valve you have.įirst open up your toilet. Ball Valve 4 1/2 Float for Toilet Cisterns Or Water Tanks / Cisterns. Remove Float From Fill Valve Pull the refill tube away from the G-Max fill valve with your fingers. Lift the lid off the toilet tank and place it on a flat surface out of the way. If you determine that you have a problem with your toilet fill valve, you should try adjusting the water level before you try anything else. Viva Compact Skylo 1/2 Fill Valve SlowFill Brass Thread. Turn Off Water Supply Turn off the toilet water supply at the cutoff valve behind the toilet. Turn that handle all the way to the right until its tight. ![]() That hose goes into your wall or floor, and there will be a handle at the base of the hose. ![]() Step 2: Identify the adjustment stem Look inside the tank there you will see a long, tiny tube that is attached to the fill valve. If you hear the sound of water flowing, or any sounds indicating that water is moving when it is not, you either have a damaged fill valve or a leak. TOTO TSU99A.X (Our Top Choice) TOTO TSU99A. Your toilets water supply comes through a hose thats often on the left side of the toilet. How to Adjust Cylinder Toilet Float Step 1: Follow steps 1 and 2 for the ball-and-arm float. If you listen to your toilet when it is not supposed to be flushing, and you hear any sounds that resemble a toilet being flushed, you probably have a damaged fill valve. The best way to start is simply to listen to the sounds it makes. Before performing any repairs on your toilet, you need to do your best to figure out what is wrong with it, if anything. ![]()
0 Comments
Leave a Reply. |